My reloading equipment shortcomings

[RAF]

Since I bought my new Tikka in 300WSM I've been planning on hand loading for it. I have pretty much everything I need, equipment wise, to hand load other calibers, but since I started messing with this 300 WSM, I've found that a lot of what I have won't work with this caliber. First thing was the chamfering/deburring tool. It wouldn't fit. The short neck and stubby body of the brass wouldn't allow the brass to reach the blades. That meant a trip to the gun shop and buying a new one made by RCBS. Nice tool, but $20 after taxes .
For years I've been using the Lee hand held priming tool. No good for this caliber. Have the right shell holder but the base of the brass won't fit into the slot so it's out . Have an RCBS primer that fits on my press. It's a lot slower but it'll work.
I wanted to see how far a full load of powder would fill the brass. Suddenly realized that I didn't have a big enough container to transfer powder from powder measure to scale. Use 30-06 brass which works fine for everything but the 300 WSM. Fortunetly I lucked out yesterday. When I bought a bag of brass yesterday the 50 bag had 51 so I have a spare. Stuck in a used primer and should be good to go . Measured off 65.5 grains of 4350 and, oh oh, the brass won't fit in the neck of my powder funnel. Considered heading back to the store to see what was available but then tried a homemade fix . I cut off a good portion of the neck of the funnel and it worked. Hope it doesn't cause problems with my other bullet, but we'll see. Might be making that trip to the store anyway.
I'm sure something else will come up before I get this done ;D

[bubba]

raf

factory loads are looking pretty good ! lol

keep at it, the 300 is a good round.

[RAF]

You're right Bubba, factory ammo would be a lot cheaper BUT, not half fun . I, and a lot of other if not all hand loaders, take a lot of pride in a finished bullet especially if it shoots as well and probably better that factory loads. Get plenty of satisfaction from taking game with it. It's part of the firearms hobby.
By the way, I did make a decision today on bullets. Decided on the Hornady Interbond and picked up a hundred. Will be using 4350 but the gun shop is out of it. Might scout around and see if someone else has some and then the fun begins.